FeaturesWatch it workEstimating & BoQHow it worksSolutionsPricingCertificationContestAbout & teamFounderFAQResourcesContact

Home › Use cases

Made for the work of estimating.

The kinds of measurements estimators take every day, with the unit and a check for each trade. Allowances below are common rules of thumb. Always follow your specification and supplier data.

TradeWhat you measureUnitCommon allowance or check
FlooringFloor area by room and finish; skirting lengthm², mTiles: add 5 to 10 % for cuts and breakage, more for patterns or diagonal layouts
PaintingWall and ceiling area, net of openingsm²Multiply by the number of coats; check coverage per litre on the product data sheet
DrywallWall and ceiling board area; framing lengthm², mA 1,200 × 2,400 mm board covers 2.88 m²; allow for offcuts
ElectricalPoints (sockets, lights, switches); cable runsnumber, mAdd an allowance for drops, bends and terminations on cable lengths
PlumbingPipe length by diameter; fittings and fixturesm, numberCount fittings separately from straight pipe
Concrete and structureVolume of slabs, beams, columns, footings; formwork area; steelm³, m², tonneSteel kg per m³ of concrete should look reasonable against past jobs
BlockworkWall area, net of openings; lintelsm², numberAbout 11.6 blocks per m² for 400 × 200 mm blocks with 10 mm joints; add 3 to 5 % for breakage

Flooring, painting, drywall

Areas for floors, walls and ceilings, and lengths for skirting and trim. Measure the net wall area once and use it for plaster, paint and board.

Electrical and plumbing

Counts for sockets, lights and fixtures, and lengths for cable or pipe runs.

Concrete and structure

Areas and lengths that feed slab, beam and column quantities. See concrete volume and formwork and the rebar weight chart.

General contracting

One place to combine take-off from several drawings into a bill of quantities, level by level.

Try Free Beta VersionSee the 3D take-off

Locked in the beta

This feature is part of the full TapeLine experience.